- For mounting on your wall or molding
- Shade can hide imperfection by covering   edges of unsymmetrical windows
- Eliminates the 1/4" gap around the shade   which results from an inside mount
- Makes your window appear larger
- Provides a more open view & allows more   light in as the shade can stack higher above   the window
- Full use of the windowsill as the shade is   flush with the wall

Measurement:
With a steel measuring tape (cloth tapes are not accurate), provide measurements of the exact area you want to cover, including any overlap on the surrounding wall. All measurements should be rounded down to the nearest 1/8 inch. No deductions will be taken from outside mount measurements. Note: You must add at least 2 inches above the window to allow space for mounting brackets.
 

- For mounting inside the window recess.
- A finished, built-in look without covering your   window molding.

Measurement:
Measure width (from left to right) at inside top, center and bottom of window opening with a steel measuring tape. Use the narrowest width measurement (round down to the nearest 1/8 inch).
Measure height (from top to bottom) at inside left, center and right of window opening. Use the shortest length measurement (round down to the nearest 1/8 inch). No deductions will be taken from height measurement.
If your window is considerably out of square, consider Outside Mounting to conceal the irregularity.

IMPORTANT: For operating clearances, it is necessary to make inside mount shades 1/2 inch narrower than the inside window measurement (11 A inch for each side). When placing orders, specify whether or not you have taken the 1/2 inch deduction. We will then make the shades with appropriate deduction for the inside mount. NOTE: Min. 2 ? 2 1/2 inch window depth opening is required for inside mount.

CEILING MOUNT
State whether inside or outside mount and refer to above instructions.

NOTE: All headrails come with 2 end-routed grooves for easy installation. Mounting brackets and screws are provided.